Boot on LVM root partition in Raspbian

Tested in Raspberrypi 2 Model B / Raspbian Jessie

It’s possible booting on a LVM root partition using a external USB disk instead a SD card in Raspberrypi. Steps are the next (create lvm partitions is out of this post):

Check if your raspberrypi supports booting from initrd, is necessary for activate LVM on system boot:

~ $ zcat /proc/config.gz | grep INITRD

If don’t exist /proc/config.gz load configs before:

~ $ modprobe configs

If result is “y” (usually) then create initrd file:

~ $ mkinitramfs -o /boot/initramfs.gz

In /boot/cmdline.txt file change the root partition replacing:

~ $ root=/dev/mmcblk0p2

with lvm disk using mapper designation, supposing vg0 as lvm group and lv01 as lvm volume:

~ $ root=/dev/mapper/vg0-lv01

You can add rootdelay=5 because interfaces can take a while to appear. At last add:

~ $ initramfs initramfs.gz

at the end of file /boot/config.txt. Finally reboot, with a little luck your rapsberrypi should boot on the new lvm root partition.

Leave a Reply

Your email address will not be published. Required fields are marked *